Study of the Mechanical Properties of Polymers and Their Comparison Using Epoxy and Polyester Mixtures

Effect of Mixture of Resin and Polyester

Authors

  • Doaa Jabbar Abed Department of Physics, College of Education for Pure Science Ibn-Al-Haitham, University of Baghdad, Baghdad, Iraq
  • Shatha Hashim Mahdi Department of Physics, College of Education for Pure Science Ibn-Al-Haitham, University of Baghdad, Baghdad, Iraq

DOI:

https://doi.org/10.52763/PJSIR.PHYS.SCI.69.3.2026.134.140

Keywords:

epoxy resin, unsaturated polyester resin, hybrid polymer composites, wear resistance, com- pressive strength, scanning electron microscopy (SEM), morphology

Abstract

 This study investigates the effect of varying mixing ratios between epoxy resin and unsaturated polyester resin on the mechanical and morphological properties of hybrid polymer composites. Six different blend ratios were prepared, ranging from 100% epoxy to 100% polyester. Abrasion resistance was evaluated using a Pin-on-Disc device under applied loads ranging from 500 g to 2500 g. The results showed that increasing the epoxy content significantly enhanced wear resistance. Under a 2500 g load, the residual weight increased from 0.3283 g for the 20% epoxy sample to 1.6947 g for the 100% epoxy sample, indicating reduced material loss due to the higher hardness and crosslink density of epoxy. Compressive strength was measured using a bold harris No. 36110 hydraulic press, following ASTM D695. The highest compressive strength was observed in the 100% epoxy sample (6.1 MPa), while the lowest value (0.6 MPa) was recorded for the 40% epoxy / 60% polyester blend, indicating weak interfacial bonding and poor structural compatibility. Scanning electron microscopy (SEM) analysis revealed features such as phase separation, particle agglomeration and microcracks in the hybrid samples, suggesting inadequate resin compatibility and non-uniform mixing. Overall, the results highlight that optimizing the epoxy-to- polyester ratio is essential to enhance both the mechanical performance and structural integrity of hybrid polymer composites.

 

Downloads

Published

2026-11-17